Basket: £0.00 +vat
Serck Motorsport
Power pour Fuel additive
Incl. Tax: £21.60 Excl. Tax: £18.00
Power Pour The Real deal Fuel additive
or Add to Wishlist


Power Pour The Real deal Fuel additive Unleaded fuels present a problem with the cylinder pressures, high RPM's, boost and nitrous volumes associated with today's racing engines. This results in having to limit compression ratio's and ignition timing and thus limits performance. Jon Webster experienced problems along these lines whilst using commercially available addiitives in his nitrous injected big block Ford Mustang. Jon was already planning a change to a turbo combination and could only see the problem worsening with the new combination. To try and solve these problems Jon commissioned a highly respected chemist in the Petro-Chemical industry to design an additive that was free of both lead and propylene oxide that would enable commercially available unleaded pump fuel to be run at the high cylinder pressures associated with forced induction road and race engines. Initial tests were carried out in 2002 using Jon's nitrous injected 525ci Mustang, the results were as follows; Fuel Additive C/R Timing MPH Nitrous Comments Optimax Other 2% 10.5 : 1 22 deg 141 150hp More timing = Detonation Optimax Power Pour 2% 10.5 : 1 30 deg 144 150hp No Detonation Optimax Power Pour 2% 10.5 : 1 33 deg 146 150hp No Detonation Optimax Power Pour 2% 10.5 : 1 28 deg 148 200hp No Detonation Following on from the tests with Jon's Mustang, Power Pour was next tested in the Street Elminator 698ci '56 Chevy of John Hales at the 2002 National Finals at Santa Pod. The car had previously run with a commercially available fuel additive and had run a best of 9.28 / 155mph (with no nitrous used). It was intended to run the nitrous for the first time at this meeting but to start with it was decided to do a normally aspirated shake down pass. The car ran 9.28 / 158mph on that pass, the only thing that had been changed was Power Pour was used instead of the commercially available fuel additive. With 4 degrees of timing taken out (to give 24 degres) the nitrous was turned on for the first time. The car ran flawlessly and recorded an 8.79 / 166mph pass. After the run the engine was compression tested and proved to be in first class condition. The biggest surprise of all came on the following run when a driver error saw all the nitrous but no additional fuel going into the engine causing a very lean condition which should have resulted in severe engine damage. Initial compression tests read within normal limits and a more thorough inspection revealed nothing more serious than slightly coloured spark plugs! Part of the brief given to the chemist was to produce something that would help to protect engines in these sort of situations and while the test wasn't carried out on purpose it certainly proved the quality of Power Pour. Upon hearing this story a Stock Car racer asked to try Power Pour. The rules there allow limited modifications and he had been experiencing detonation problems when trying to run high compression ratios. He was delighted to report no detonation, clean and smooth power delivery and up to 500rpm more on the straights, resulting in two heat wins and a runner up finish in the final! Since its initial development Power Pour has contributed to speed and ET records and Event and National Championship wins within the UK Drag Racing circuit and is now being used in many other disciplines of Motorsport, including 2 stroke motorcycles were it was used to set the 250 cc Historic Isle of Man TT lap record. This is also Prefect high performance road going vehicles which have mapable fuel and ignition systems, seeing increases in excess of 6% in overall performance along with added protection for their engines. The other area of growth has been racers previously using expensive race fuel in some cases have swapped to unleaded pump fuel with Powerpour and have saved over 40% in fuel costs, with no loss of performance.

Customer Review

Write Your Own Review

You're reviewing: Power pour Fuel additive

How do you rate this product? *

1 1 star
2 2 star
3 3 star
4 4 star
5 5 star

Delivery & Return Policy

You can manage content from : CMS==> Static Blocks ==> Delivery & Returns


The Quality management system of Serck Motorsport is registered to BS:EN:ISO9001:2000 by the British Standards Institute. Registration number FS52488
Designed & Developed by Neoteric UK